SSC/Structure/BiPolytropes/51RenormaizePart2: Difference between revisions
| Line 632: | Line 632: | ||
</table> | </table> | ||
<font color="red">Correct!</font> | <font color="red">Correct!</font> | ||
====Time-Dependent Euler Equation==== | |||
We begin with the form of the, | |||
<div align="center"> | |||
<span id="PGE:Euler"><font color="#770000">'''Euler Equation'''</font></span><br /> | |||
<math>\frac{dv_r}{dt} = - \frac{1}{\rho}\frac{dP}{dr} - \frac{d\Phi}{dr} </math><br /> | |||
</div> | |||
that is relevant to our study of radial oscillations in [[SSCpt1/PGE#PGE_for_Spherically_Symmetric_Configurations|spherically symmetric configurations]]. | |||
==Example Models Along BiPolytrope Sequence 0.3100== | ==Example Models Along BiPolytrope Sequence 0.3100== | ||
Revision as of 17:57, 19 August 2022
Radial Oscillations in (nc,ne) = (5,1) Bipolytropes
Logically, this chapter extends the discussion — specifically the subsection titled, Try Again — found in the "Ramblings" chapter in which we introduced a total-mass-based renormalization of models along sequences of bipolytropes.
Building Each Model
Basic Equilibrium Structure
Most of the details underpinning the following summary relations can be found here.
|
Quantity |
|
|
|||||||||||||||||||||||||||
|
|
|
|
|||||||||||||||||||||||||||
|
|
|
|
|||||||||||||||||||||||||||
|
|
|
|
|||||||||||||||||||||||||||
|
|
|
|
|||||||||||||||||||||||||||
|
Note that, for a given specification of the molecular-weight ratio, , and the interface location, , in which case,
|
|||||||||||||||||||||||||||||
Additional Relations
Core
The analytically prescribed radial pressure gradient in the core can be obtained as follows.
|
|
||
|
|
||
|
|
||
|
|
Also,
|
|
Hence,
|
|
||
|
|
For comparison, in hydrostatic balance we expect …
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
This matches our earlier expression, as it should.
|
Takeaway Expression
|
Envelope
Given that, for the envelope,
|
|
and, |
|
|
|
|
we deduce that,
|
|
|
|
|
|
|
|
|
|
|
As a cross-check …
|
|
|
|
|
|
|
and,
|
|
|
|
|
|
|
That is,
|
|
|
|
|
|
|
Correct!
Time-Dependent Euler Equation
We begin with the form of the,
Euler Equation
that is relevant to our study of radial oscillations in spherically symmetric configurations.
Example Models Along BiPolytrope Sequence 0.3100
For the case of and , we consider here the examination of models with three relatively significant values of the core/envelope interface:
- Model D : Approximate location along the sequence of the model with the maximum fractional core radius.
- Model C : Approximate location along the sequence of the onset of fundamental-mode instability.
- Model A : Exact location along the sequence of the model with the maximum fractional core mass.
Model C
Here we examine a discrete representation of a model along the sequence whose core/envelope interface is located a .
See Also
|
Appendices: | VisTrailsEquations | VisTrailsVariables | References | Ramblings | VisTrailsImages | myphys.lsu | ADS | |