PGE/RotatingFrame

From jetwiki
Jump to navigation Jump to search

NOTE to Eric Hirschmann & David Neilsen... I have moved the earlier contents of this page to a new Wiki location called Compressible Riemann Ellipsoids.

Rotating Reference Frame

Coordinate Transformation

At times, it can be useful to view the motion of a fluid from a frame of reference that is rotating with a uniform (i.e., time-independent) angular velocity Ωf. In order to transform any one of the principal governing equations from the inertial reference frame to such a rotating reference frame, we must specify the orientation as well as the magnitude of the angular velocity vector about which the frame is spinning, Ω→f; and the d/dt operator, which denotes Lagrangian time-differentiation in the inertial frame, must everywhere be replaced as follows:

[ddt]inertial→[ddt]rot+Ω→f×.

Performing this transformation implies, for example, that

v→inertial=v→rot+Ω→f×x→,

and,

[dv→dt]inertial=[dv→dt]rot+2Ω→f×v→rot+Ω→f×(Ω→f×x→)

=[dv→dt]rot+2Ω→f×v→rot−12∇[|Ω→f×x→|2]

(If we were to allow Ω→f to be a function of time, an additional term involving the time-derivative of Ω→f also would appear on the right-hand-side of these last expressions; see, for example, Eq.~1D-42 in BT87.) Note as well that the relationship between the fluid vorticity in the two frames is,

[ζ→]inertial=[ζ→]rot+2Ω→f.

We begin by restating the Lagrangian representation of the intertial-frame Euler equation:

dUidt|inertial

=

−1ρ∂p∂xi−∂Φ∂xi.

Drawing from Chapter 4, §25 of [EFE] — where the Cartesian components of the inertial-frame velocity (v→inertial) are represented by Ui and the Cartesian components of the rotating-frame velocity (v→rot) are represented by ui — the LHS of the Euler equation transform as follows:

dUidt|inertial

→

dUidt|rot−ϵimkΩkUm,

where we also recognize that,

Ui

→

ui+ϵijkΩjxk.


Both of these expressions make use of the three-element Levi-Civita tensor, ϵijk. Its six nonzero component values are …

ijk ϵijk   ijk ϵijk
123 +1 132 -1
312 321
231 213

Hence, for example, transforming the x-component (i=1) of U→ gives,

U1

→

u1+ϵ1jkΩjxk=u1+ϵ123Ω2x3+ϵ132Ω3x2=u1+Ω2z−Ω3y;

transforming the y-component (i=2) gives,

U2

→

u2+ϵ2jkΩjxk=u2+ϵ231Ω3x1+ϵ213Ω1x3=u2+Ω3x−Ω1z;

and transforming the z-component (i=3) gives,

U3

→

u3+ϵ3jkΩjxk=u3+ϵ312Ω1x2+ϵ321Ω2x1=u3+Ω1y−Ω2x.

These are the same three components that arise from the vector expression (from above),

v→inertial=v→rot+Ω→×x→;

we therefore recognize that, Ω→×x→=ϵijkΩjxk. We note as well that, Ω→×x→=−ϵijkΩkxj.


As viewed from the rotating frame of reference, then, the Euler equation becomes,

dUidt|rot−ϵimkΩkUm

=

−1ρ∂p∂xi−∂Φ∂xi

⇒ddt[ui+ϵijkΩjxk]

=

ϵimkΩk[um+ϵmjkΩjxk]−1ρ∂p∂xi−∂Φ∂xi

⇒duidt+ϵijk[(dΩjdt)xk+Ωj(dxkdt)]

=

ϵimkΩk[ui+ϵijkΩjxk]−1ρ∂p∂xi−∂Φ∂xi

Continuity Equation (rotating frame)

Applying these transformations to the standard, inertial-frame representations of the continuity equation presented elsewhere, we obtain the:

Lagrangian Representation
of the Continuity Equation
as viewed from a Rotating Reference Frame

[dρdt]rot+ρ∇⋅v→rot=0 ;


Eulerian Representation
of the Continuity Equation
as viewed from a Rotating Reference Frame

[∂ρ∂t]rot+∇⋅(ρv→rot)=0 .


Euler Equation (rotating frame)

Applying these transformations to the standard, inertial-frame representations of the Euler equation presented elsewhere, we obtain the:

Lagrangian Representation
of the Euler Equation
as viewed from a Rotating Reference Frame

[dv→dt]rot=−1ρ∇P−∇Φ−2Ω→f×v→rot−Ω→f×(Ω→f×x→) ;


Eulerian Representation
of the Euler Equation
as viewed from a Rotating Reference Frame

[∂v→∂t]rot+(v→rot⋅∇)v→rot=−1ρ∇P−∇[Φ−12|Ω→f×x→|2]−2Ω→f×v→rot ;


Euler Equation
written in terms of the Vorticity and
as viewed from a Rotating Reference Frame

[∂v→∂t]rot+(ζ→rot+2Ω→f)×v→rot=−1ρ∇P−∇[Φ+12vrot2−12|Ω→f×x→|2] .


Centrifugal and Coriolis Accelerations

Following along the lines of the discussion presented in Appendix 1.D, §3 of [BT87], in a rotating reference frame the Lagrangian representation of the Euler equation may be written in the form,

[dv→dt]rot=−1ρ∇P−∇Φ+a→fict,

where,

a→fict≡−2Ω→f×v→rot−Ω→f×(Ω→f×x→).

So, as viewed from a rotating frame of reference, material moves as if it were subject to two fictitious accelerations which traditionally are referred to as the,

Coriolis Acceleration

a→Coriolis≡−2Ω→f×v→rot,

(see the related Wikipedia discussion) and the

Centrifugal Acceleration

a→Centrifugal≡−Ω→f×(Ω→f×x→)=12∇[|Ω→f×x→|2]

(see the related Wikipedia discussion).

Nonlinear Velocity Cross-Product

In some contexts — for example, our discussion of Riemann ellipsoids or the analysis by Korycansky & Papaloizou (1996) of nonaxisymmetric disk structures — it proves useful to isolate and analyze the term in the "vorticity formulation" of the Euler equation that involves a nonlinear cross-product of the rotating-frame velocity vector, namely,

A→≡(ζ→rot+2Ω→f)×v→rot.

NOTE: To simplify notation, for most of the remainder of this subsection we will drop the subscript "rot" on both the velocity and vorticity vectors.

Align Ω→f with z-axis

Without loss of generality we can set Ω→f=k^Ωf, that is, we can align the frame rotation axis with the z-axis of a Cartesian coordinate system. The Cartesian components of A→ are then,

i^:Ax=ζyvz−(ζz+2Ω)vy,

j^:Ay=(ζz+2Ω)vx−ζxvz,

k^:Az=ζxvy−ζyvx,

where it is understood that the three Cartesian components of the vorticity vector are,

ζx=[∂vz∂y−∂vy∂z],ζy=[∂vx∂z−∂vz∂x],ζz=[∂vy∂x−∂vx∂y].

In turn, the curl of A→ has the following three Cartesian components:

i^:[∇×A→]x=∂∂y[ζxvy−ζyvx]−∂∂z[(ζz+2Ω)vx−ζxvz],

j^:[∇×A→]y=∂∂z[ζyvz−(ζz+2Ω)vy]−∂∂x[ζxvy−ζyvx],

k^:[∇×A→]z=∂∂x[(ζz+2Ω)vx−ζxvz]−∂∂y[ζyvz−(ζz+2Ω)vy].

When vz = 0

If we restrict our discussion to configurations that exhibit only planar flows — that is, systems in which vz=0 — then the Cartesian components of A→ and ∇×A→ simplify somewhat to give, respectively,

i^:Ax=−(ζz+2Ω)vy,

j^:Ay=(ζz+2Ω)vx,

k^:Az=ζxvy−ζyvx,

and,

i^:[∇×A→]x=∂∂y[ζxvy−ζyvx]−∂∂z[(ζz+2Ω)vx],

j^:[∇×A→]y=−∂∂z[(ζz+2Ω)vy]−∂∂x[ζxvy−ζyvx],

k^:[∇×A→]z=∂∂x[(ζz+2Ω)vx]+∂∂y[(ζz+2Ω)vy],

where, in this case, the three Cartesian components of the vorticity vector are,

ζx=−∂vy∂z,ζy=∂vx∂z,ζz=[∂vy∂x−∂vx∂y].

Related Discussions

Tiled Menu

Appendices: | VisTrailsEquations | VisTrailsVariables | References | Ramblings | VisTrailsImages | myphys.lsu | ADS |